Rotating top Table.
Rotate the table top
counter-clockwise to make the top bigger.
Rotate the table top clockwise to make the top smaller.
From the closed position, rotate the table top counter-clockwise and the outer
ring drops down before the top panels move outward, then upward and then inward.
After they come together the outer ring moves up to help support the top panels
and give more leg room.
From the open position, rotate the table top clockwise and the outer ring drops
down, the top panels move outward, drop down and then move inward. After they
come together the outer ring moves up to to be flush with the top and makes the
Small diameter is 56 1/4". Large diameter is 75 1/2".
Table height is 30". Top thickness is 4 1/2"
This is an expensive table to build. The cost of materials is over $2200.00.
Only one size is available. If the size was made bigger, the difference in
diameter between opened and closed would always be 19 1/4" regardless of the
The plans were last revised on 2/28/2017.
The plans must be printed to scale, not to fit, because the templates are not
Table 24x36.pdf must be printed on 24 X 36 to a scale of 1" = 1'-0.
Table 36x48.pdf must be printed on 36 X 48 to a scale of 1" = 1'-0. The templates in this file are drawn to
a smaller scale in the Table 24x36.pdf file and can be made from those drawings.
Because this would be costly to build, I have not built it
myself. I have not made a through check of the bill of materials so the count of
the number of some of the screws may be off a little. Because of this you may
contact me with questions about the plans.